EPadLink ePad Vision Podręcznik Użytkownika Pobierz pdf (Strona 12)

ePad Product Family User’s Guide

ePad LS

The ePad LS power and data cable uses a new design,

where only one cable reaches the ePad LS unit itself, a

USB connector for the host computer is at the other end

and a power supply adapter connects in between. The

ePad LS requires the use of the external power supply

(included) at all times.

WARNING: Only use the power adapter supplied with the

product.

Assembling the data/power cable is easy:

• Plug the mini-D connector to the ePad LS port,

located in the receding bay (bottom) of the ePad.

• Plug the power supply to a power source and

attach the other end to the ePad LS data/power

cable, at the reception block.

• Plug the USB connector to the host computer.

Replacing the ePad protective layer – specific models only

In order to increase the lifespan of the ePad signature

sensor (e.g. ITO) and LCD, a replaceable film is employed

for protection. The protective film may, however become

worn out after prolonged use. To ensure continued

reliable use of the ePad, it is necessary to replace the

protective film when it becomes worn out. To replace the

protective film, please follow these steps:

ePad LS

• Remove bezel by pushing on the button located

below the front area of the ePad LS. Apply direct

force to release bezel.

• With your fingers and starting from the upper right

corner, peel off the old protective layer.

• Install new protective layer making sure dovetails

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Brak uwag

EPadLink ePad Vision Podręcznik Użytkownika Strona 12